Why is cedar used in closets

Many boards have a rabbet on either end so they can interlock with the next board in the row. If possible, use the off-cut of one board to start the next row, so the two boards interlock.

Dry-fit each row before installation. Apply a zigzag bead of adhesive to the back of the board. Tip the groove of the board over the tongue of the last row to fit them together. While the adhesive is still wet, check the board for level and make adjustments as necessary. Nail the board in place. Continue installing boards in this manner until the back wall is covered. Then install the cedar on the sidewalls, allowing the back edge of the boards to cover the cut ends at the corners.

Be sure that sidewall rows line up with the rows on the back wall, or the mismatched seams will appear crooked at the corners. Transfer the measurements to the board and, using a jigsaw, rip it along the tongue side. Tip the board into place over the tongue of the previous row. Nail through the board's face close to the top of the wall. Using a miter box and handsaw, straight-cut the ends of a piece of cove molding so it fits across the top of the back wall.

If you need two pieces to span the wall, join them with a scarf joint, angling the ends 45 degrees to overlap each other. Using a brad nailer, tack the molding through its center into the top of the wall framing. Cut a piece of cove with a degree miter at the end that will go in the corner. Position the miter so the long point is on the back of the molding. Using a coping saw, cut the front edge of the miter along the molding profile revealed by the miter, angling the saw about 5 degrees to make a slight back cut.

If the blade binds, back out the saw and cut in from the edge to make a relief cut, then start again. When the whole profile is cut, check the coped piece against the molding on the back wall to be sure it butts tightly. Then cut the piece to length and nail it in place. Repeat this process on the other wall. Cookie banner We use cookies and other tracking technologies to improve your browsing experience on our site, show personalized content and targeted ads, analyze site traffic, and understand where our audiences come from.

By choosing I Accept , you consent to our use of cookies and other tracking technologies. Either option could be used within your custom closets, and both offer the same protection benefits. If the scent seems to fade, which it will over time, you can refresh it by applying cedar oil. If you think that cedar closet liners are something that you might want, talk to your custom closet company first to determine which type of liner would work better for your situation and budget. You can have the cedar installed or you can order it and install it on your own.

The best time to do this is when your closet is already empty as you prepare for your custom closet installation. Using cedar wood in your closet eliminates the need for you to treat your wool and cotton clothing.

Particularly if you live in an older home which is prone to insect infestation, this can save your clothing, as well as your health, from the effects of pesticides like mothballs.

Install the cedar along the walls of your closet, using a hammer and nails to attach the wood. Attach the planks to the existing walls at the studs, using a stud finder to help you locate them. Sand the cedar using fine-grade sandpaper at the end of each season.

This exposes a new layer of the wood to the air, and allows the natural oils in that fresh layer to evaporate and release their aroma. Buy cedar chips from a local home improvement store. These chips -- which vary in size -- can produce the same aroma as cedar planks. Select chips made from eastern red cedar. Place the cedar chips in multiple locations throughout your closet. Put the chips in mesh or cloth bags to allow air to circulate through the chips. Place the bags in all the closet's corners, as well as on any shelves.

Shuffle the cedar chips routinely.